View source for Nova Galaxi DVR 1644 Lathe with a Oneway Brand Vacuum Chuck

Locattion:  [[Welcome_to_the_Factur_Wood_Turning_Studio_WiKi!|Wood Turning Studio]][[File:Nova_DVR_Galaxi_1644_Lathe.jpg|200px|thumb|right|Nova DVR Galaxi 1644 Lathe]] 

=Policies for the Nova Galaxi DVR 1644 Lathe=
'''This is a private lathe. It is not for public use. If you need to use it because of the size of your project make arrangements with Roger Scott. He will supervise your use of his lathe whenever you need it.
'''

=Information=
*[http://www.teknatool.com/wp-content/uploads/2016/10/566-Galaxi-DVR-1644-manual_FINAL-Remote-II_October-2016.pdf Nova Galaxi DVR 1644 Lathe Manual]

=Videos=

=Accessories=
*[[Oneway Brand Cyclone Vacuum Chucking System]]

=Consumables=

=Routine Maintenance=

After each use:

Clean the work area and Lathe. Vacuum shavings and dust from the Headstock, Tailstock, under the Toolslide and in between the bed.
Wax exposed cast iron parts with a good quality paste wax, especially the bed rails. Buff out the wax thoroughly.
Check tightness of nuts and bolts.

Monthly:

Lubricate, with one or two drops of light-weight oil, the tailstock quill threads, index pin shaft, and the Toolslide camshaft (remove plastic plugs) and Toolslide front camshaft bore.

6 Months:

Lubricate the tailstock slot with one or two drops of lightweight oil.

----
[[Welcome_to_the_Factur_Wood_Turning_Studio_WiKi!|Go to the Wood Turning Studio Page]]

[[Welcome_to_the_Factur_Dead_Links_Wiki!|Report Dead Links]]